25
English
Settings
5
24
Settings
5
●
Programming the remote control memory for complete opening only:
Choose the remote control button you want to use to control your gate.
Place the remote on the crosshairs inscribed
on the casing:
●
Changing the operating mode for already-programmed remote
controls:
To switch a remote control from "complete opening only" mode to "pedestrian or com-
plete opening" mode, simply carry out the "Programming remote controls for pedestrian
or complete opening" operation explained above. The latest programming overwrites the
previous memorised mode.
To switch a remote control from "pedestrian or complete opening" mode to "complete
opening only" mode, simply use the "Programming remote controls for full opening only"
operation explained above. The latest programming overwrites the previous memorised
mode.
Hold down the button to be memorised
until the PROG LED blinks slowly (the
DANGER LED
will come on while the
button is being held).
1
Release the button. It is now memorised.
2
●
Programming the remote control memory for pedestrian or complete
opening:
Choose the remote control button you want to use to control your gate.
Place the remote on the crosshairs inscri-
bed on the casing:
Hold down the button to be memorised
until the PROG LED blinks slowly (the
DANGER LED
will come on while the
button is being held).
1
Release the button.
2
Within 10 seconds, press again on the button to be memorised until the PROG LED blinks
slowly (the DANGER LED
will come on while the button is being held).
3
Release the button. It is now memorised.
4
Once the programming cycle is complete, only the PROG and ON/OFF LEDs will be
lit, with the electronics on standby to record the leaves' travel.
All settings that have been recorded are deleted, including remote controls programmed, the
gate's travel and the operating mode.
●
Subsequent adding of remote controls
Repeat the steps given in "Programming remote controls" (see page 24).
Over and above 16 transmitters, programming will fail. Delete all controls (see
above) and reprogramme.
Programming a new remote control cancels the previous programmed gate travel.
Start "Learning the leaves' travel" again (see page 26).
●
Deprogramming remote controls
• Press the reset button and hold it for 7 seconds.
> As you do, all four LEDs will come on.
1
• Release the reset button.
> All four LEDswill go off for two seconds.
> The ON/OFF LED will come on again.
> The PROG LED will come on again.
2
LEDs
reset button
SGA6000 gb.qxd 12/02/08 17:54 Page 24
