19
English
Mounting the arms
3
18
Mounting the arms
3
❏
Mounting the arms onto the leaves.
Mounting the arms onto the gate requires drilling holes in the leaves. Complete the following
steps:
Check that the motors are in the
unlocked position
.
1
Drill the leaves using an 8-mm drill
bit.
4
• Remove the arm from the fastening lug.
• Using a mallet, drive the bolts all the way into the gate.
• Assemble the fastening lug on the leaves, then re-install the arms into the fastening lug.
5
8
Through the fastening lug, mark the
points on the leaf bracket where holes
will be drilled.
3
10
Check that the gate is closed and in contact with the stop.
Push the arm fully open against the leaf.
Make sure that the fastening lug is flat against the leaf.
2
Open the arm hinges completely onto the leaf
bracket. This is a guarantee that the leaf is properly
locked.
Self-check before the next step
Did you open the arm hinge completely when mounting the arms on the leaf
brackets?
SGA6000 gb.qxd 12/02/08 17:54 Page 18
