11
ThE mOTOr IS rEAdy TO OPErATE.
It will operate in sequential mode by default.
Gate travel self-learning
Self-learning of the gate's travel is essential when commissioning the motor.
The gate must be closed before auto programming is started and at least one remote control must have been programmed.
The movement of the gate leaves during auto programming are always carried out at a reduced speed.
The two opening/closing cycles must be complete for auto programming to take place. If the movement of the gate is interrupted during
auto programming, the process is delayed and will resume next time the gate is fully opened.
If the
=
=
indicator light flashes after 2 complete opening/closing
cycles, consult the repair help on page 17.
......
1
3
4
1
12
13
14
=
=
=
=
Auto-programming consists of making the gate perform two gate leaf
opening and closing cycles.
[1].
Move the remote control away from the receiver.
[2].
Press the programmed button to open the gate fully. The gate opens at
slow speed.
If the gate does not open, or moves in the direction of closing,
check the motor wiring (see page 9).
[3].
Once both leaves of the gate are fully open, press the programmed
button on the remote control again. The gate closes, one gate leaf at
a time.
[4].
Initiate a second opening and closing cycle. This time, the two gate
leaves will close at the same time. At the end of the second closing,
the
=
=
indicator light will go out, which indicates the end of the self-
learning phase.
OPErATION
The motor can operate in sequential mode or automatic closing mode.
Sequential mode
: successive presses of the same remote control button will lead to the following movements: Open, Stop, Close, Stop, Open etc.
Automatic closing mode
: pressing the programmed button of the remote control will cause the gate to open. The gate will close automatically after 30
seconds. If photoelectric cells are installed, any movement in front of the cells will cause the gate to close automatically after 5 seconds.
The gate can be held in the opened position by giving a stop command during the time delay. To close the gate, press the remote control button again.
3-button remote control - using the central button
With the gate closed, pressing the central button on the remote control causes the gate to open in pedestrian mode (motorised opening of the gate by motor
M1).
If the gate is moving, pressing the central button of the remote control will cause the gate to stop.
For more information, refer to the user section.
Summary of Contents for HOME MOTION Axovia 220B
Page 1: ...EN Installation instructions Axovia 220B...
Page 25: ...5...