EN
Tilt & Li
,
25 RTS
20
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
Quickly press the
PROG
button on the RTS control
point to be programmed:
The motorised product moves up and down: this RTS control point is programmed
in the motorisation.
!
If the motorisation is no longer in programming mode, repeat Step
2.3.1.
Programming the RTS control point
then perform Step
2.3.4. Recording
the RTS control point
.
2.4. TIPS AND ADVICE ON INSTALLATION
2.4.1. Questions about the drive?
Observations
Possible causes
Solutions
The motorised product
does not operate.
There may be some
radio interferences.
Unplug the motor
supply cable and
reconnect the battery to
the motor.
One or more batteries
have been mounted
backwards.
Verify that batteries
are all mounted in the
correct manner.
One or more batteries
leak in the battery tube.
Replace the batteries.
Batteries (inside battery
tube) are weak.
Check whether the
batteries are weak and
replace if necessary.
The control point battery
is weak.
Check whether the
battery is weak and
replace it if necessary.
The control point is not
compatible.
Check for compatibility
and replace the control
point if necessary.
The control point
used has not been
programmed into the
motor.
Use a programmed
control point or program
this control point.
PROG.
