23/40
Copyright © 2016 Somfy SAS. All rights reserved. Non contractual images
Chronis & Soliris Smoove
[ Back to Contents ]
Interactive operating instructions
Configuration of the Sun Sensor
You can configure the sun sensor.
1. Select between the wired sensor (only possible with Soliris devices),
radio sensor (only possible with Chronis Smoove UNO S, Chronis
Smoove IB+ or Soliris Smoove devices), or no sensor.
2. Confirm your selection.
For "Radio sensor", see "
Back to Pairing the Radio Sensor
".
Pairing the Radio Sensor
Pairing the Radio Sensor with a Smoove device
1. Confirm "Radio sensor" and "Pairing".
2. Press on the program button of the Sunis WireFree io, until the green LED lights up.
3. Confirm "Start".
> The following message appears: "Searching for wireless sun sensor..." .
> After a short time, the following message appears: "Wireless sun sensor connected" and the
LED on the Sunis Wirefree io blinks.
4. If the message "No wireless sun sensor found" appears:
• Check the distance between the sensor and the device.
• The sensor might already be paired with another device. In this case, reset the Sunis Sensor:
press the program button of the Sunis WireFree io for 7 seconds until the green LED blinks.
Repeat the pairing procedure.
Configuration
Wired sensor
Radio sensor
Pair
Radio sensor
Read key
Pair
Stop
Start
PROGRAM BUTTON
GREEN LED
7. SETTINGS MENU
