Somerdata AROW Series, Additional Instructions For Installation And Operation

Page: 16 / 82

AROW Series
Data Diode
Installation and Operation 4-1
4. CONFIGURATION
In this Section
I
NTRODUCTION
4-1
S
ETTING THE CONTROL PORT
IP
ADDRESS
4-1
S
ETTING THE DATA PORT
IP
ADDRESS
4-2
Introduction
To integrate AROW into a network, the IP address for each Control
and each Data port must be set. AROW will have been factory-set
with network addresses before delivery
Setting the control port IP address
The control port IP address can only be set from a machine on the
same sub network. You will need the MAC address for each control
port to be set. This is printed on each module panel.
Open a Windows command prompt (Start, Run, enter command or
CMD depending on your operating system). For linux, open a
command line terminal.
From the command prompt enter the new ARP (Address Resolution
Protocol) entry for the IP address you want to set as shown below:
This will associate a network address with a MAC address.
ARP
–S 192.168.xxx.xxx 00-20-4A-xx-xx-xx
(for linux: arp -s 192.168.xxx.xxx 00:20:4A:xx:xx:xx)
Hit return
Open a new command prompt.
Type
ping –t 192.168.xxx.xxx
(linux: ping 192.168.xxx.xxx)
The “pings” will fail to start with but will give an indication of progress.
Back to the first command prompt telnet to the same IP address
using port 1.
e.g. Telnet 192.168.xxx.xxx 1
Hit return. (message ‘failed to connect’ should appear within 2 to 3
seconds)
The “Pings” should start to work.