Somerdata AROW Series, Additional Instructions For Installation And Operation

Page: 12 / 82

AROW Series
Data Diode
Installation and Operation 3-1
3. INSTALLATION
In this Section
P
REPARATION
3-1
P
HYSICAL
I
NSTALLATION
3-2
C
ONNECTIONS
3-2
F
IT
SFP
MODULES
3-2
R
ECORD
MAC
ADDRESSES
3-3
N
ETWORK CONNECTIONS
3-3
C
ONNECT POWER
3-3
N
ETWORK REQUIREMENTS
3-3
C
ONTROL
N
ETWORK
C
ONNECTIONS
3-4
Preparation
These instructions should be followed before installation, and any
time the unit is moved, connections changed or re-installed.
Check the items received to ensure that they match your data
input/output configuration requirements.
No special tools are required. You will need a large flat headed
screwdriver.
In common with other electroonic equipment of this class, AROW
needs to be installed in a controlled environment where the
temperature will not go above 40°C or below 0°C, and where the
relative humidity is between 15% and 55%, and is non-condensing.
Ensure that you allow the unit to stabilise in this environment before
use, especially if it has been subjected to transportation in low-
temperature or high-humidity environments
Check that the cables that you will be using to connect to the data
inputs and the control and data Ethernet ports are of correct length
and are well and correctly labelled. The cables should be tied into a
wiring loom for tidiness. Electrical Data cables should be a minimum
of Cat 5e for GBE operation, optical cables should be laser
compatible (yellow sheath), 9/125 terminated for LC connection.