SOLTRON XL-75 DYNAMIC POWER, Operating Instructions Manual, Page: 44 / 154

43
Safety instructions for maintenance and care
Maintenance and care play a major role in deciding whether your sunbed
meets your requirements satisfactorily. Compliance with the specified
maintenance intervals and thorough maintenance and care are therefore
absolutely essential.
You can call up the current operating hours of the parts to be serviced in
preset mode – see separate instructions “Presettings”, Order
number 1003844.
Refit any protective devices (e.g. filter panels) after finishing working on
the sunbed.
Please note that the device must be inspected regularly by our customer
service or an approved specialised company every 12 months (from date
of commissioning) to maintain its proper condition.
Danger to life!
Disconnect the sunbed from the power supply when performing
maintenance work requiring opening of the device.
See Page 45.
Risk of burning!
XL-75 Dynamic Power: When changing the UV low pressure
lamps, the enclosed chip card must always be used!
The UV low pressure lamps can only be operated at the cor-
rect power if the lamp set and chip card are exchanged simul-
taneously.
If the old chip card is left in the unit, the new lamp set is oper-
ated at too high power and the user may suffer heavy burns!
Danger of burns!
Only use the specified genuine UV lamps and filter panels !
Using other UV lamps leads to modified radiation. This could
potentially result in severe burns to the user!
The use of other UV lamps and filter panels invalidates CE
conformity and the GS approval mark !
Caution!
Use only genuine spare parts of the same type! The use of
other parts voids the CE conformity!
Any liability is excluded in the case of damage or injury proven
to be the result of the use of non-genuine spare parts.