CIE-H10A User Manual Ver. 1.1
- 17 -
2
Installation and Test
2.1
Installation
In this section, we explain the operation of CIE-H10A through a test. Basically, its input
and output ports are independently used. Thus, you can use either the input ports only for
monitoring or the output ports only for control. However, you can also correlatively use
those ports by using the MACRO mode on the output ports.
Before testing CIE-H10A, you should connect the Ethernet port to a PC. It will be no
problem if the Ethernet connection is established through network hubs.
Figure 2-1 the connection between CIE-H10A and a PC
2.1.1
Setting Network Aera
This step is for setting both CIE-H10A and your PC to be located on the same network to
establish a TCP connection.
⚫
Setting of the PC
Add or change the IP address of the network adapter on your PC.
Click [Windows Control Panel] >> [Network Connections] and right click of your
mouse to get into [Properties of the Network Adapter], then you will see the
properties of [Internet Protocol (TCP/IP)]. Press the [Advanced Menu] button and add
an IP Address as shown below.
Figure 2-2 adding / changing an IP address
