15
www.solencosa.co.za | [email protected] | 086 606 8915
Please make sure the water tank cover is put back into place correctly before
the water tank is reinserted.
If the water-tank is inserted incorrectly, the tank full indicator will flash.
Remove the water tank and reinsert to turn the indicator off and resume
normal use.
At all times, avoid water entering the unit. It may cause
an electrical hazard
and damage the unit.
Set up continuous drainage
This dehumidifier has a continuous drain hole that can be connected to a plastic
pipe with a 15 mm inner diameter. Water can be automatically plumbed in or
drained into a sink, a larger receptacle or through the wall into an outside drain.
Please follow the steps below to setup your unit for continuous drainage.
1.
Cut off the cover for the continuous drain on the back of the unit.
2.
Pull out the water tank and connect a water pipe of inner diameter 15mm to
the drain connector, and ensure the connection is tight.
3.
Return the water tank back into position within the unit.
This unit uses gravity fall to dispose water hence the drain should be lower than
the dehumidifier water outlet. Be sure to run the water pipe downward and let the
water flow out smoothly. Do not kink or bend the pipe.
NOTE: When the continuous drain feature is not being used, reverse the pipe
installation, to start the water collecting in the water tank.
The permanent drain can be used in conjunction with a water pump (e.g. when
draining from a cellar) to lift the water upwards.(Water pump is NOT included)
