9
www.solencosa.co.za | [email protected] | 086 606 8915
UV Light Button ( For air purification )
To select
“UV”
press the
“UV”
button and the indicator light to the
right of the button will illuminate. The UV light improves the air quality
by destroying germs, bacteria and fungi.
PLASMA IONIZER Button (ionization function)
To activate the ionizer press the Plasma ionizer button. The LED to
the right of the button will illuminate to show the mode is active.
The ionizer can refresh the air while killing viruses, dust mites,
mould and airborne allergens.
HUMIDITY SETTING Buttons
Press UP / DOWN buttons to select the desired relative humidity
level. The default relative humidity is 55%. When a relative
humidity of 35% is selected, the compressor will not stop until the
water tank is full. Please note these buttons will not adjust the
desired humidity in smart mode.
TIMER Button
When the button is pressed, the led to the left of the button will
illuminate to show the mode has been activated. The timer can
be turned off again by pressing the timer button. The indicator
LED will then turn off. The Timer can be used in 2 different ways
Delayed power-on: With the unit on standby, activate the timer
mode and use the "UP" and "DOWN" buttons to select how many
hours you require the unit to start in.
Delayed power-off: With the unit turned on, activate the timer
mode and use the "UP" and "DOWN" buttons to select how many
hours you require the unit to turn off in.
INTELLIGENT DEFROST
The appliance will defrost automatically as programmed once the
coil Sensor detects the temperature is too low, to prevent ice from
building within the unit. The defrost indicator will light up to show this
mode is active. Once the defrosting process has finished, the
appliance will recover to its previous running mode.
TANK-FULL
If the water tank is full, the indicator light will flash, please empty the
water tank to continue operation. The light will also illuminate if the
tank is incorrectly fitted.
