3
www.solencosa.co.za | [email protected] | 086 606 8915
•
Never use the mains plug or an external timer as a switch to start and
turn off the dehumidifier. Only use the provided ON/OFF button located
on the control panel.
•
Always place the unit on a dry and flat stable surface.
•
The appliance should not be installed in a laundry or wet room where
the humidity is higher than 85% RH.
•
Do not dry laundry directly above the unit. To prevent water entering the
dehumidifier, laundry should be placed at least 1 meter away from your
dehumidifier.
•
Do not place the unit next to heat sources (e.g. electrical fires,
fireplaces, etc.)
•
Avoid mishandling the dehumidifier. Dropping or throwing the unit can
cause damage to the internal components and increases the risks of
operating it.
•
Do not store or use, petrol, paint, solvents or other flammable vapours or
liquids in the vicinity of this dehumidifier or any other appliance.
•
This dehumidifier must not be used in spaces where there is a high
concentration of gases, solvent or other volatile organic compounds; in
very dusty environments; in any domestic, commercial or industrial
environment where air composition is flammable.
•
Remove water from the tank before storing the dehumidifier
•
This dehumidifier must always be stored and transported upright,
otherwise irreparable damage may be caused to the compressor; if in
doubt we suggest waiting at least 24 hours before starting the unit.
Energy Saving and Unit Safety Protection Tips
•
Do not cover or restrict the airflow from the outlet or inlet grills. Do not
operate and follow the troubleshooting procedure if the self-opening
louvers do not open when power is on.
•
For maximum performance the minimum distance from a wall or
objects should be 20 cm.
•
Keep the filters and grills of the unit clean. Under normal conditions, the
filters and grills should only need cleaning once every three weeks
(approximately).
•
Since the filters remove airborne particles, more frequent cleaning may
be necessary depending on the air quality. Vacuum both the mesh and
optional carbon filters and wash the mesh filters with hot soapy water
and dry them before placing them back in the unit
