14
www.solencosa.co.za | [email protected] | 086 606 8915
at a later stage. Please note the unit should not be placed directly against a
radiator or other heat source. When positioning your Solenco dehumidifier, ensure
that it is placed clear of any obstacles that may limit the air movement, and it
should be placed on a dry flat surface.
Please Note: Do not force castors to move over carpets or uneven surfaces, nor
move the unit
with water in the tank as it may tip over and spill.
WATER DRAINAGE
When the water tank is full, the unit will stop automatically. When this happens the
TANK FULL red light will show on the control panel.
Note: Only empty the water tank when it is full or before moving or storing the unit
There are two ways to dispense collected water.
Use the internal water tank.
When the tank is full, the unit will automatically stop
running, and the Full indicator light will flash. Grip the
tank by its handle securely, and carefully pull out.
Empty the water tank and reinsert it into the
dehumidifier. The tank must be in place and
securely positioned for the dehumidifier to operate
again. The dehumidifier will re-start when the tank is
replaced to its correct position.
NOTES:
Do not remove the water tank immediately after the unit stops. Please wait a
while to avoid the water dripping into the unit and causing damage.
Only empty the water tank when it is full or before moving or storing the unit.
Do not rest the tank on the floor because the bottom of the tank could be
uneven and the tank may fall and cause the water to spill.
When you remove the tank, do not touch sensors or any parts which are
situated behind tank. Doing so may damage the product. Be sure to push the
tank back gently all the way into the unit. Banging the bucket against
anything or failing to push it securely into place may cause the unit not to
operate.
Do not remove or damage the float switch in the water-tank, otherwise the
machine will stop working.
