Solectek skyway, User Manual

Page: 49 / 52

49
radius_server RW 10.20.20.3 set radius_server [server_ipaddr]
show radius_server Base Station only. Sets Radius
Server IP address
radius_timer RW 86400 set radius_timer [period]
show radius_timer
Base Station only
Set Radius reauthentication period,
in Seconds
radius_user RW wpa1@host.loc
al
set radius_user [name]
show radius_user
Client Unit only
Set Radius client user name
reboot W
reboot
Reboot system
rfnetname RW NAME_1 set rfnetname [netname]
show rfnetname
Set RF Network Name
rmod RW set rmod [macaddr] [streams] [bpsk-1/2 |
qpsk-1/2 | qpsk-3/4 | qam16-1/2 | qam16-
3/4 | qam64-2/3 | qam64-3/4| AUTO] Set Remote Modulation/Streams
on
route R
show route
Show IP route table
rssi R show rssi Show Local Recv Signal Strength
savecfg W savecfg Save configuration to permanent
memory
serialnum R
show serialnum
Show system serial number
set R set ? Set ? for commands
show R show Show commands
snmp RW enabled
public – for all
strings
192.168.1.1 for
trap manager set snmp enable=[yes|no]
set snmp [read-community|rc]=[abcdef]
set snmp [trap-community|tc]=[abcdef]
set snmp [trap-manager|tm]=[a.b.c.d]
show snmp Set SNMP configuration
parameters
status R status Show system status
streams RW 1 show streams
set streams
[1 | 2]
Show / Set the number of MIMO
data streams. Limited to 1 for
Access 50.
sysmode RW retains
sysmode
show sysmode
set sysmode [MULTIPOINT_MASTER |
MULTIPOINT_SLAVE] Show / Set the MULTIPOINT
operating mode
tz RW “+00:00” tz [+hh:mm | -hh:mm] Set/Show time zone