11
2.
Feed the Ethernet CAT5 Cable through the
Feedthrough Body
(pre-installed on the enclosure at
the factory) and insert the RJ-45 connector to the female connector inside the enclosure.
3.
Install the
Compression Nut
and hand tighten until the cable resists slipping when gently
pushed or pulled. Lightly wrench-tighten, being careful not to overtorque the
Compression Nut
.
The unit with properly installed feedthrough appears as follows:
Notes
:
(a) Removal of the RJ45 plug from the radio requires a tool such as a thin screwdriver, or opened
paperclip. Care must be taken not to damage the Feedthrough Body or RJ45 plug.
(b) The total combined length of the Ethernet cables between the radio and your network access
device (hub/switch/PC) must not exceed 300 feet.
(c)
Once mounted in a permanent location, additional weatherproofing tape (included) should be
applied around the assembled fitting to further enhance durability.
(d) In order to maintain FCC compliance, the use of shielded CAT5 cable is required.
C.
B
RACKET
P
REPARATION
The SkyWay mounting bracket is pre-assembled at the factory for ease of installation.
