ENG - 29
03917401.ENG rev. 0
(7)
Checking battery electrolite level and charge:
Batteries require a very careful handling and frequent checkings. Proceed as shown below:
(1) Always keep batteries dry and cleaned.
(2) Regularly check terminal cleanliness. If dust is settled, terminals should be loosened, cleaned and smeared witha
neutral grease layer.
(3) Metal objects must not be placed over the battery.
(4) Batteries or containers containing acids should carefully be handled.
(5) Monthly or every 200 hours check the acid level and supplement it with DISTILLED WATER required. Level should not
exceed the battery inside mark.
(6) Never use open flames to light battery components: there is explosion danger.
(7) In winter, batteries should be detached and placed following the manufacturer’s instructions.
Before battery is charged with an external charger, disconnect both terminals.
(8)
Fuel decanting filter drainage ( optional) :
Loosen the wing nut (3) located at the lower side of the glass
vessel and let go all the acrued water. Shut again off the wing nut
and check it does not drip.
Fig. 7.2.8.
(9)
Replace the fuel filter element (engine):
The fuel filter is cladded and cannot be cleaned. It must be replaced at least once every 12 months.
To perform the filter change: Shut off the cock located at the tank delivery. Unscrew cover filter with a chain spanner.
Screw the new filter to the cover with the hand and at the same time replace the rubber seals. Carry out the operations at
heading 5.1.1 bleeding air from the fuel system.
(10)
Injector checking:
This operation shall be made by a SOLÉ DIESEL service. If a hand-pump is available, monitor the calibration of
injectors, by verifying that the pressures are those listed in paragraph 2.6 of this manual.
(11)
Checking incandescent spark plugs:
Supply power to the glow plugs during a maximum of 6 seconds and make sure that they become incandescent, spend
more time could damage glow plugs. If not renew them.
(12)
Air filter change and clearing:
Engine is provided with an intake air filter. This filter has two
components, part (A) and (B). To perform filter element cleaning
(A), use water with soap as explained in chapter 7.1. Filter assy,
parts (A) and (B) must be changed both after two years of
service. See Fig. 7.2.12.
Fig. 7.2.12
