ENG - 18
03917401.ENG rev. 0
Run the engine for a few minutes until the cooling circuit is properly filled and free of air pockets. Check the coolant level
and replenish if necessary.
warning!
after the first 50 hours of engine duty and at six months or 1000 hours intervals thereafter, addrust inhibiting
agent AC88 to the coolant in the same proportions as indicate earlier. The cooling liquid mixture must be
topped up with identical mixture and totally drained and replaced every 2 years.
warning!
the use of coolants that are not in conformity with the above prescriptions will cause damage to engine
components and invalidate the terms of the guarantee.
4.2.3 REFUELING
Always use clean, filtered gas oil. Never use either kerosene or heavy oils. On topping up with fuel, use a funnel with a
metallic mesh filter, to keep out impurities or foreign bodies which may cause problems in the fuel injection circuit.
Whenever possible, keep the fuel tank full, as temperature changes may cause condensation of the damp air present in
the tank so that water accumulates at the bottom, giving rise to corrosion or making it impossible to start the engine if this
is aspirated by the fuel pump.
Check all tank filling plugs located at the boat deck are sealed..
warning!
Do not use diesel fuel mixed with water or any other foreing substances
warning!
Always use top quality fuel of certified origin. the use of diesel fuel that does not comply with the technical
specifications indicated above will cause serious damage to the injection system and hence to the engine and
also invalidate the terms of the guarantee
4.3 INSTALLATION
warning!
When water-cooled engines must be located in an enclosed place or protected by guards or a cabinet, it is
important to ensure thatcombustion air is freely supplied and freely expelled from the area
The above recommendation is of primary importance in relation to the perfect operation of the engine because the hot air that
it generates must never be routed to the area of the combustion air intake cleaner.
If the users fails to take these precautions, a hot air recirculation system will be formed thus reducing engine power output and
obstructing proper cooling.
In these cases it is advised to take steps to avoid taking in engine combustion air from the place in which the engine is
installed. This is achieved by placing the suction filter, or a suction pre-filter, outside the place in which the engine is installed.
4.4 INDICATIONS FOR REMOVAL / DISPOSAL OF WASTE MATERIAL
warning!
Disposal of waste material must be carried out in conformity with established legislation in the country of
installation.
