Question:
I have a regular 10 amp battery charger, can I use it to recharge the
CS2000?
Answer:
No, only the supplied wall charger should be used.
Question:
Is the CS2000 goof proof?
Answer:
No, jump starting instructions must be followed. Read and understand
all safety and operating instructions in this manual and those found in
the owner’s manual of any vehicle being jump started before using your
CS2000.
Question:
I’m recharging my CS2000. Should the green CHARGE COMPLETE light
immediately come on?
Answer:
No. First the yellow CHARGING light will come on to indicate the charging
process is beginning. Then, the red POWER LEVEL lights come on in
sequence as the level of charge increases. Finally, the green CHARGE
COMPLETE light will come on, but only when the CS2000 approaches
full charge.
Question:
How long should I charge the CS2000?
Answer:
It should be charged for a minimum of 30 hours when new. Your CS2000
can be left on the wall charger continuously. When recharging with the
wall charger, the CS2000 should be charged for 4 to 6 hours per light that
remains unlit when the TEST button is pressed.
Question:
How do I know when the CS2000 is fully charged?
Answer:
Follow all charging instructions. Remove the CS2000 from the wall
charger and press the TEST button. If all power indicator lights come on,
it is fully charged.
Question:
How can I test the battery in my CS2000 to see if it needs to be
replaced?
Answer:
We recommend that you use a 100 amp battery load tester. Load the
CS2000 battery for 6 seconds with a 100 amp load and it should maintain
at least 9.5 VDC.
Summary of Contents for Car Start CS2000
Page 11: ......
