OPERATION AND MAINTENANCE
Portable Power Source Features
The CS2000 provides plenty of power for starting vehicles – more than enough to start
most cars.
The CS2000 will power most 12VDC accessories equipped with a male 12 Volt outlet
plug. The DC outlet features automatic overload protection.
The unit features a test switch and LED lights. State of the art circuitry allows the unit
to remain continuously connected to the charger without the risk of overcharging.
Safety Features
Safety storage holsters prevent accidental sparking of clamps and rotate 90° for easy
clamp removal and replacement. Always re-holster the clamps after use.
Cable grooves lock the cables for clean storage (no hazardous or unsightly dangling
wires). Always re-wrap cables and properly secure clamps after each use.
The CS2000 contains the latest technology with its 12 Volt sealed, non-spillable battery
and may be stored in any position.
RECHARGING PROCEDURES
Note:
Upon initial purchase, your CS2000 should be charged for a minimum of 30
hours.
Test Button, Charging, Power Levels and Charging Complete LEDs
Recharging Your CS2000
There are two ways to charge your CS2000. The recommended method is automatic
charging with the provided wall charger. An alternative method is through the DC power
outlet using the provided 12 Volt Male-Male Extension Cord. This second method is
not automatic and must be monitored because the CS2000 could be damaged due to
overcharging.
Charging using the supplied wall charger (recommended method). This is the
recommended charging method because it features automatic charging, eliminating
the possibility of overcharging. With this method, the wall charger is connected to
the CS2000 through a small charging jack (pin jack), located on the rear of the unit.
Recharging takes approximately 4 to 6 hours for each light that does not come on
when the test button is pressed. With this method, your CS2000 can be left connected
to the wall charger indefinitely.
Summary of Contents for Car Start CS2000
Page 11: ......
