Fig. H
Fig. G
Fig. F
Fig. E
1.
Ensure the heater and emitter are cool and the power supply is disconnected before disassembly.
2.
Remove the heater from its mounted position should it not be safe to work on it while mounted.
3.
Remove the screws from the terminal box (Fig. E) and lift off the cover.
C A U T I O N
C A U T I O N
C A U T I O N
C A U T I O N
Unplug/switch off from the mains power before any attempts are made to replace the emitter.
Contact your distributor for the correct replacement quoting model type and rating from
rating label. We recommend you read through the procedure and refer to the parts diagram
on the back page of this manual before commencing work.
R E P L A C I N G T H E E M I T T E R
4.
Disconnect the emitter wires from the connector blocks by unscrewing the screws
highlighted above in Fig. F.
5.
Unscrew the four screws (see Fig. G) from the end casing and remove from the heater
body. Repeat at opposite end.
6.
Slide out the side covers from both ends and slide out the guard from either end as shown
in Fig. H.
8
