7.
Remove the two screws as highlighted on in Fig. J to take out the side reflector bracket
and reflector assembly that allows access the emitter holding clip. Repeat at opposite end of
emitter.
8.
Where the emitter wires are fed through the gasket into the terminal box (Fig. J), gently
pull the emitter wires through the body of the heater so the wires exit the terminal box.
9.
At the opposite end of the emitter, the wire will be clearly visible in the emitter wire tube so
gently pull the long wire (Fig. K) out of the tube until it is free.
10.
One at a time pull the spring clips back in the direction shown in Fig. L and lift up the
ceramic caps of the emitter to remove it from the heater.
11.
The emitter should now be removed from the heater. Refit the new emitter in reverse
order ensuring the ceramic caps are correctly seated in the emitter holders, no wires are
trapped and all screws are fully tightened.
Fig. K
Fig. L
Fig. J
9
