20
ADJUSTMENTS
6.3.1 NORMAL SEEDS (N position)
Follow the following steps for sowing with
NORMAL SEEDS
:
Fig. 40
3
2
4
Fig. 42
8
9
Fig. 41
F
N
1-
Remove the locking ring (3, Fig. 40) as shown in the image.
2-
Place the bolt (2, Fig. 40) as shown in the figure.
3-
Turn the spindle (4, Fig. 40) for regulating the dose.
4-
Fix the spindle position placing the locking ring (3, Fig. 40).
5-
Place the turbine air regulator in
N position
(Fig. 41).
6-
Fit the gear (8, Fig. 42) with the gear (9, fig. 42), as shown
in the image.
6.3.2 SMALL SEEDS (F position)
Follow the steps below for sowing with
SMALL SEEDS
:
Fig. 44
F
N
Fig. 43
3
2
4
1
Fig. 45
8
9
10
1-
Remove the locking ring (3, Fig. 43) as shown in the image.
2-
Place the bolt (2, Fig. 43) in the shaft fitting groove, as shown
in the image
3-
Turn the spindle (4, Fig. 43) for regulating the dose.
4-
Fix the spindle position placing the locking ring (3, Fig.
43).
5-
Place the turbine air regulator in
F position
(Fig. 44).
6-
Pull the gear (8, Fig. 45) until releasing it from the gear (9,
Fig. 45) and fit it to the gear (10, Fig. 45).
THE MICRO-DOSAGE SYSTEM ALLOWS BETTER
DISTRIBUTING SMALL AND NORMAL SIZED
SEEDS IN REDUCED AMOUNTS.
READ THE ADVISABLE VALUE FOR SMALL SEEDS
WITH THE F MICRO-DOSAGE SYSTEM IN THE
DOSAGE CHARTS (SEE SECTION 10).
CHECK THE CLEANING BRUSH CONDITIONS BE-
FORE START SOWING SMALL SEEDS.
DO NOT EXCEED THE 25 MEASURE IN THE REG-
ULATION SCALE FOR MICRO-DOSING SMALL
SEEDS (1, FIG. 43).
OPEN THE SEED DISPENSER INLET (FIG. 45 BIS).
Fig. 45 BIS
A
Summary of Contents for A-6000/NS PLUS
