3.2
Setting of parameters by using of optical
”
USB-IRDA” converter
The module is equipped with the
”
IRDA” infrared optical interface, that can be used for configuration through the
”
USB-IRDA”
converter (USB-to-optic) or through the
”
BT-IRDA”
converter (Bluetooth-to-optic).
All parameters that is necessary to set-up during common operation can be configured by
”
USB-IRDA”
converter.
The settings can be performed through the transparent casing without necessity to open the module’s cover. This
is the significant advantage especially if the module is used in humid environment and has been sealed by additional
silicon filling (additional adaptation for IP-68 proofing).
Any changes in module’s settings can be performed in
Module configuration table
that opens by click on the
”
Read device” button in ”WACO OptoConf” program window. View of configuration table is depicted in figure
Figure 9: WB169-SI2 module configuration table
In the
upper section of the table
there are
”
read only” type of parameters (factory settings) that refer to the
identification of the module and its components.
There are following parameters:
WB169-SI2
24
