Page 2 - 15
TL49J
CONTROLS/PRE-OPERATION
HOSES, TUBES AND FITTINGS
To inspect the hoses, tubes and fittings:
1. Inspect all hydraulic hoses, tubes, and fittings for wear, leakage, or damage.
2. Make sure the hoses are properly routed to avoid sharp edges, kinking, and scuffing.
3. Inspect the tubes for dents or other damage that may restrict fluid flow.
4. Make sure all hoses and tubes are held firmly in their support brackets.
5. Check under the chassis for fluid that has leaked. Hydraulic fluid leaks are easily visible on the
ground.
LOWER CONTROL STATION
With no personnel or materials on the platform, test the operation of each control from the lower
controls (refer to Figure 2-8)
Figure 2-8 –
Lower Control Station
OPERATING CONTROLS
Use the following procedure to operate and test the machine from the lower controls:
1. Plug the battery disconnect (refer to Figure 2-9).
2. At the lower controls, twist and pull the emergency stop switch outwards to the ON position.
3. Turn the control select switch to lower controls (turn to the right).
Figure 2-9 –
Battery Disconnect
Emergency
Stop Button
Emergency
Lower Switch
Outrigger LED
Lights
Control Select/
Ground Operation
Switch
Platform Raise/
Lower Button
Outrigger Raise/
Lower Button
Upper
Controls
Lower
Controls
Off
