![background image](http://html1.mh-extra.com/html/snell-and-wilcox/iqbrt8/iqbrt8_manual_1309063030.webp)
IQBRT8
SECTION 41b
IQBRT8OPS 020403
Version 1 Issue 7
41b.30
Setup/Logging
Preset Unit
This item sets all adjustment functions that include
a preset facility, to their preset values.
Note that this is a momentary action.
Restart
This function allows the unit to reboot and all
power-up settings to be enabled.
This is an easier method than switching the mains
power on and off.
Lock Mode
This function allows the option to reframe the
input(s) to different reference signals.
If no locking inputs are detected then the unit will
revert to the internal mode (free-running at 48 kHz)
The locking information will be displayed in the
information area.
Selections available are:
Video
Unit will lock to the video input Reference signal
AES_Reference
Unit will lock to the AES Reference.
Note that when locking to the AES reference the
pull in range is ±2 Hz, if the reference is 48 KHz
but out of this range (PLL unable to maintain lock)
the information display will indicate "
ERR
" instead
of "
OK
" and
Fsi
will indicate the reference input
sampling rate to the nearest 1 kHz.
AES Input_1
Unit will lock to the signal at Input 1
Internal
The unit will free-run at a sample rate of 48 kHz.
Software version
This item shows the version of the software fitted
in the module.
Serial Number
This item shows the serial number of the module.
Build Number
This item shows the factory build number of the
module.
Logging
If a logging device is attached to the RollCall™
network, information about various parameters will
be reported to the logging device assigned in the
Remote Control Interface system. (See Section 1,
The RCIF Menu System)
The following information to be made available for
logging:
Input 1 to 8 Change
These report any changes of the sample rate and
presence of inputs 1 to 8.
AES Ref Change
This reports any changes of the sample rate and
presence of the AES reference signal.
◀
Video Ref Change
This reports any changes of the sample rate and
presence of the Video reference signal.
Factory preset is nothing enabled