BK-S216
User Manual
- 24 -
¾
It is recommended to ensure the designed paper holder angle at the range from 11
˚
and 39
˚
;
Fig.4.6.6 Paper inlet
¾
When the paper roll O/D is over 100mm, the buffer organ should be used;
If the inlet angle of your designed paper holder is less than 11
˚
as shown above, we suggest
that you should design the buffer organ and also ensure the moving area of the buffer shaft
over 16mm. When the buffer shaft reaches the limit position of 16mm, the unit spring force is
from 1N to 2N or about 0.5N at the primary position. If it is within 39
˚
or above, the printer buffer
organ can be used. However ensure paper moving scope within 39
˚
shown as above in feeding
paper, otherwise paper could be scratched.
Fig.4.6.7 Buffer structure
z
Caution in paper holder installation
The paper holder is installed on the printer separately. In order to ensure reliable paper feed, you
should pay attention to the followings in paper installation:
¾
Keep paper path smooth, avoid sharp folder to cause overload;
¾
Avoid that paper rubs with sharp object, in order to prevent paper thermal layer damaged;
¾
Make sure that paper center is in consistent with the center of the paper-feeding path, in order
to prevent paper from slant during printing. (For position dimension, please see shape
dimension in section 3.2.1)
