Snap-On EEWB334A, Operation Instructions Manual

Page: 38 / 192

38 EEWB334A
5-33
5-34
5-35
5-36
20
26
21
28
26
5.10.3 Start Optimization/Weight
Minimization.
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions, or check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 20
Optimization – Minimization ( Fig. 5-33 ).
The OPTIMIZATION MENU “OP.1” screen ( Fig. 5-34 )
is displayed.
If an optimization/weight minimization result has
already been saved, press the
21 key ( Fig. 5-34 );
The program then continues from the step where it
was interrupted, with the relative measurement values
and the balancing optimization / weight minimization
may continue.
At this point, you can choose whether to continue with
Optimization (Key
26 ), or go to Minimization (Key 28 ).
5.10.3.1 OPTIMIZATION
— Clamp the rim only.
— Move the gauge arm into position on the rim, based
on the desired ALU.
— Perform a measuring run.
— In the BALANCING menu press key 20 ( Fig. 5-33 ).
The “OP.1” screen page appears ( Fig. 5-34 ).
— Press the menu key 26 (Fig. 5-34).
The OPTIMZATION “OP.2” screen ( Fig. 5-36 ) is
displayed.