SMS TAKEDO-3VF, User Manual

Page: 7 / 75

TAKEDO - 3VF NXP USER MANUAL Release P09.1 dated 01-12-2017
7
3) Check the following parameters:
Parameter Description Unit SMS setting Value to be set Value
S6.1.2 Language Italian
Select according to
country of
S6.2.2 Application AsynchMotor PermMagnSync
4) Enter data in the following parameters:
Parameter Description Unit SMS setting Value to be set Value
P2.1.2 Motor Nominal Voltage
V
400 Motor rating plate data
P2.1.3 Motor Nominal Frequency
Hz
8.00
Motor rating plate data
P2.1.4 Motor Nominal Speed
RPM
60
Motor rating plate data
P2.1.5 Motor Nominal Current
A
I Inverter
Motor rating plate data
P2.1.6 Motor Cos Phi 0.90 Motor rating plate data
P2.1.7.1 Lift Rated Speed m/sec 1.00 LIFT data
P2.1.7.2 Pulley Diameter mm 320
LIFT data
P2.1.7.3 Gear Ratio 1.01
LIFT data
P2.1.7.4 Ropes Ratio 1:1
LIFT data
P2.1.7.5 Update Data No Yes
P2.1.12 Encoder Type Incremental
Encoder Type:
Incremental or EnDat
P2.1.13 Encoder Direction Not inverted
Not inverted
if motor is going up
Inverted
if motor is going up
P2.1.14 Calculated Poles 0
Make sure the number of
poles calculated
matches
the number for the motor
P2.1.16 Motor Rs 0
If motor rating is
unknown, leave at 0
P2.1.17 Motor Xs 0
If motor rating is
unknown, leave at 0
P7.3.1.1
Pulse/revolution
(Number of encoder pulses)
2048
Number of pulses /
revolution of installed
encoder
5) If the encoder is an EnDat type, follow the procedure illustrated in paragraph
12.9 A) of the full MANUAL
step by step.
6) If the encoder is an incremental type, follow the procedure illustrated in paragraph
12.9 B) of the full
MANUAL step by step.
7) If it does not work perfectly, see the full MANUAL.
8) For other accessory functions such as POWER LIMIT, ONE FLOOR TRAVEL ONLY, DIRECT FLOOR
ARRIVAL etc. see the full manual.