14
Installation Guide
5. Position heater, making sure the flexible
hoses are not kinked and the electrical cable
is not snagged.
1. Turn on the electrical supply at the fused spur.
2. Set the upper rocker switch on the fascia grille
to the right (blue) and the lower switch to the
left or right — the fan should run.
3. Set the upper rocker switch to the left (red) and
the middle rocker switch to the right (electric
heating). Heat will start to flow immediately.
Increasing the fan speed will not increase the
heat output in the electric heating mode.
4. Turn on the central heating system.
5. Set any room thermostat/s to maximum.
Commissioning
6. Set the upper rocker switch to the left (red),
the middle rocker switch to the left (hydronic
heating) and the lower switch to the left
(normal output). The fan should run and heat
will flow within a few minutes.
7. Balance the central heating system if Space
Saver is installed on the same circuit as panel
radiators.
8. When the installation is working correctly,
remember to reset any thermostat/s to its
normal setting.
6a. Fit overlay grille (if supplied) over fixed grille.
6b. Fix heater to plinth.
