COSMOS DRIVER SERIES 3000 - USE AND MAINTENANCE MANUAL
8.2 LEDs “LINE” and “24VDC”
The two LEDs “LINE” and “24VDC” indicate the status of the main power supply (LINE) and auxiliary power supply
(24VDC).
LINE
24VDC
LINE
24VDC
<50V
X
OFF
X
>50V and < VDC BUS MIN
X
FLASH
X
>VDC BUS MIN
X
ON
X
X
<~16V
X
OFF
X
>~16V and <20,4
X
FLASH
X
>21,4
X
ON
X = Not consistent
If the main power supply LINE is inferior to VDC BUS MIN, the driver is disabled.
If the auxiliary power supply 24VDC is inferior to 20,4V, the driver might not operate correctly.
8.3 LEDs “FLT” and “STS”
FLT and STS are LEDs indicating the driver general status.
FLT (fault) consists of a red LED, while STS (status) consists of an orange LED and a green LED.
Status
FLT
STS
Hardware error or critical firmware
ON
Seq.
Seq.
Driver retrievable error
OFF
Seq.
Seq.
Driver ready
OFF
OFF
OFF
Driver enabled
OFF
OFF
ON
If the STS LEDs are flashing, the following sequence occurs:
Seq.
Meaning
STS
1
Error code start
FLASH
FLASH
2
It indicates the tens in the error code
FLASH D
OFF
3
It indicates the units in the error code
OFF
FLASH U
4
Repetition of the sequence from point 1
After the simultaneous flashing of the orange and green LEDs, count the number of flashing of the orange LED and you
will obtain the number of tens in the error code; if you count the flashing of the green LED, you will obtain the number
of units in the error code.
Example: 1 flashing of the orange LED, 4 flashing of the green LED: the error code will be 14.
8.4 LEDs I1, I2 and TO
I1, I2 and TO concern the STO safety system. Their meaning is specified in details at paragraph
8.5 LEDs A and L
The LEDs A and L concern the field bus connections (F1 and F2). The field bus FLxIO has no LED.
For the field bus Ethernet IP/Sercos III, the LEDs have the following meaning:
Meaning
A
L
Disconnected cable or no network signal
X
OFF
Network signal present, but data packs absent
OFF
ON
Network signal present, data packs present
FLASH
ON
Ver. 1.07
Pag. 87