38
Chapter 13: Installation & Wiring
13-1 Installation of Cylinder
1. It should be installed at high flatness surface. For uneven surface. Shim adjustment should be done
to achieve smooth operation of slider with a minimum operating pressure of 0.1MPa.
2. Installed with utilizing both sides head cover. Do not fix cylinder
’s position through slider, as shown
in diagram (a). With overloading the bearing, operation error occurs.
Besides that, for the case of single sided fixing method (as refer in diagram (b), consultancy should
be made, due to bending of tube may occur and thus, lead to the occurs of operation error.
(a) Fixing through Slide (b) Single side
’s Fixing
There are 2 ways, as shown in diagram below, to fix cylinder
’s position.
Utilizing the installation method, with the consideration of mounting surface and situation.
(Side support, option, should be used for support purposes only.)
(c) Fastening through Upper Surface (d) Fastening through Lower Surface
3. With loading within allowable range of Hyrodless Monosashi-kun, supporting structure (LM Guide)
is still necessary to be installed as a support for the applied loading. Besides that, for the case of
long stroke, floating structure design should be brought in to overcome misalignment problem.
4. Cylinder has to be covered when it is used at environment that has chips, dust, oil mist and etc.
5. Be aware of not to harm (dented marks and etc.) the outer surface of cylinder tube, which wil l lead
to the damage of bearing and scraper. Consequently, disoperation will occur. Besies that, be aware
of not to apply too much of impact and momentum upon slider as slider is only supported by plastic
made bearing.
6. Do not apply load onto brake and scale plate, its bending will lead to operation error. Once, brake
and scale plate have been adjusted during installation state. Re-adjustment is not required and
should be advoided.
Summary of Contents for HYRODLESS MONOSASHI-KUN
