C
HAPTER
3
| Quick Installation Guide
Quick Installation Guide
– 37 –
Figure 14: Quick Setup – Wireless
■
Wireless Radio
- Enable or disable the wireless radio choosing
from the pull-down list.
■
SSID
- Enter a value of up to 32 characters. The same name of
SSID (Service Set Identification) must be assigned to all wireless
devices in your network. Considering your wireless network
security, the default SSID is set to “SMC”. This value is case-
sensitive. For example, “TEST” is NOT the same as “test”.
■
Region
- Select your region from the pull-down list. This field
specifies the region where the wireless function of the Router can be
used. It may be illegal to use the wireless function of the Router in a
region other than one of those specified in this field. If your country
or region is not listed, contact your local government agency for
assistance.
■
Channel
- This field determines which operating frequency will be
used. The default channel is set to Auto, so the AP will choose the
best channel automatically. It is not necessary to change the
wireless channel unless you notice interference problems with
another nearby access point.
■
Mode
- This field determines the wireless mode in which the Router
works.
■
Channel Width
- Select any channel width from the pull-down list.
The default setting is automatic, which can adjust the channel width
for your clients automatically.
■
Disable Security
- The wireless security function can be enabled or
disabled. If disabled, the wireless stations will be able to connect
