Smartwatch H20NV8, Installation Manual, Page: 111 / 172

SmartWatch® Network Video Recorder User Manual
111
9.2 Configuring Advanced Settings
9.2.1 Configuring PPPoE Settings
Your NVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the Network Settings screen.
Menu >Configuration> Network
2. Select the PPPoE tab to enter the PPPoE Settings screen, as shown in Figure 9. 2.
Figure 9. 2 PPPoE Settings Screen
3. Check the PPPoE checkbox to enable this feature.
4. Enter User Name , Password , and Confirm Password for PPPoE access.
The User Name and Password should be assigned by your ISP.
5. Click Apply to save and exit the screen.
6. After successful settings, the system asks you to reboot the device to enable the new settings, and the PPPoE
dial-up is automatically connected after reboot.
You can go to Menu > Maintenance> System Info > Network screen to view the status of PPPoE connection.
Please refer to Chapter Viewing System Information for PPPoE status.
9.2.2 Configuring DDNS
If your NVR is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) to be used
for network access.
Prior registration with your ISP is required before configuring the system to use DDNS.
Steps:
1. Enter the Network Settings screen.
Menu >Configuration> Network
2. Select the DDNS tab to enter the DDNS Settings screen, as shown in Figure 9. 3.