ASSEMBLE
SIDE PANELS
8
BOTTOM PLATE
BOTTOM PLATE
SELECT:
2 x 1.905 m Side Wall Sheets (Angled)
2 x 1.935 m Side Wall Sheets (Angled)
2 x 1.965 m Side Wall Sheets (Angled)
2 x 1.522 m Top Plates (Red)
2 x 1.520 m Bottom Plates (Green)
72 x 30mm Galv Clouts
8 x Rivets
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
BOTTOM PLATE
1857mm
1948mm
15mm
BOTTOM PLATE
1857mm
1948mm
Second Side
Panel
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface (corner
cutouts to face as shown).
Measurements between Top and Bottom
plates are critical to ensure wall panels fit together.
STEP 2:
•
Place 1 x 1.905m, 1 x 1.935m and 1 x 1.965m Side wall sheets on
top of timber plates, with bottom of sheets flush with each other.
•
Rivet sheets together on overlaps as shown.
STEP 3:
•
Nail wall sheets to the Top Plate at each end making
sure that the top of the sheets are flush with the top of
the Top Plate and the sides of the wall sheet overhang
the Top Plate by approx 15mm as shown.
•
Check that the Top Plate is straight then nail the wall
sheet to the Top Plate, two clouts per pan (see
fig. 1
).
STEP 4:
•
Nail the wall sheets to the Bottom Plate at each end ensuring each
side of wall sheets overhangs the end of Bottom Plate by 15mm.
Check that the distance between the Top and Bottom Plates is
correct. (As per diagram in step 1)
•
Check that the Bottom Plate is straight then nail the wall sheets to
the Bottom Plate, two clouts per pan (see
fig. 1
).
Repeat with second side panel ensuring Top Plate is as shown.
fig.1
RIB
PAN
CLOUT
TIMBER PLATE
Standard Shed —
Bottom Plate will protrude below
wall sheet by approximately 10mm.
Raised base plate shed —
Wall sheet will protrude
below the Bottom Plate by 20mm
.
15mm
15mm
1857mm
1948mm
15mm
RIVET
RIVET
RIVET
RIVET
BOTTOM PLATE
15mm
