ASSEMBLE BACK PANEL
SELECT:
6 x 1.890 m Wall Sheets
1 x 3.020 m Top Plate (Red)
1 x 3.020 m Bottom Plate (Green)
72 x 30mm Galv Clouts
10 x Rivets
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate on a
flat surface as shown (corner cutouts to face in-
wards).
STEP 2:
•
Place 6 x 1.890 m wall sheets on top of timber
Plates with bottom of sheets flush with each other.
•
Rivet the sheets together on overlaps as shown
.
STEP 3:
•
Nail the wall sheets to the Top Plate at each end making sure
that the top of the sheets are flush with the top of the Top
Plate and that the sides of the wall sheets overhang the Top
Plate by
15mm
as shown.
•
Check that the Top Plate is straight then nail wall sheets to
the Top Plate, using two clouts per pan.
STEP 4:
•
Nail the wall sheets to the Bottom Plate at each end,
ensuring that each side of the wall sheets overhangs the
Bottom Plate by
15mm
and that the distance between
the Top and Bottom Plates is correct. (As shown)
•
Check that the Bottom Plate is straight then nail
wall sheets to the Bottom Plate, using two clouts per pan
.
9
Standard Shed —
Bottom Plate will protrude below wall
sheet by approximately 10mm.
Raised base plate shed —
Wall sheet will protrude below
the Bottom Plate by 20mm
.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
TOP PLATE
BOTTOM PLATE
BOTTOM PLATE
1858mm
1858mm
TOP PLATE
TOP PLATE
15mm
15mm
1858mm
1858mm
BOTTOM PLATE
15mm
15mm
TOP PLATE
