8
Press the green ON button and the unit will sound one short beep to
indicate it is on. The water motion sensor will begin to function 5
seconds after the unit is turned ON. The alarm siren will sound when the
sensor picks up any water motion, therefore, you should wait a few
minutes for the water to settle down before turning on the unit.
If the alarm goes off immediately after you hit this green ON button,
recheck the mounting of the alarm unit. If the unit si not securely
mounted, pushing the control head will cause the alarm to sound off. If
the alarm continues to sound off whenever it is turned on, please read
the Sensitivity Adjust section.
When the unit is turned ON, it will send out a RF signal to the receiver.
The green LED of the receiver lights up.
TURN THE UNIT ON
Press and hold both the green ON and the yellow RESET buttons
simultaneously for 3 seconds, until you hear 5 consecutive beeps. The
unit is now turned OFF.
NOTE: If the water motion sensor is triggered, alarm will not stop until
3 seconds after pressing both the green ON and the yellow RESET
buttons simultaneously.
When the unit is turned OFF, it will send out a RF signal to the receiver.
The yellow LED of the receiver flashes.
TURN THE UNIT OFF
