18
NOTE: If you are not familiar with security systems, contact a
professional for connection.
The remote receiver has a three junction terminal block, so that you can
connect it to your home security system or other third party safety
device. When the receiver receives a RF (radio frequency) alarm signal, it
will activate the terminal block in 3 seconds. Resetting the receiver within
3 seconds ensures that you will not activate your home security system.
Loosen the screw at the top of and remove the blue cap. Remove the
battery door and loosen the two screws. Open up the box and you can
find a 3 junctions terminal block near the A/C adapter power jack.
The terminal block signal switching is controlled by a microprocessor. For
current switching, it is recommended to connect a K-1 type relay (not
included) to the terminal block as shown.
HOW TO CONNECT TO YOUR HOME SECURITY SYSTEM
Q. Alarm unit cannot detect underwater wave signal
TROUBLE SHOOTING
- Check the unit by hitting the ? button. If the unit does not give any beep, replace the 9V battery
with a new one.
- Check the phone jack connection between the sensor tube and the alarm unit control head. Make
sure it is connected properly.
- Check the sensitivity setting on the bottom of the underwater sensor and the depth of the sensor
into the water.
- During the 5 seconds RF transmission, the unit will not respond to any sensor triggering.
Refer to page 9.
Receiver Circuit Board
O/P
GN
PW
Common
K-1 Relay
Normal
Close
Normal
Open
A/C adapter
power jack
Channel A/B
select switch
Ext. Connection
A
B
