HGM8110DC-2 GENSET CONTROLLER USER MANUAL
HGM8110DC-2 Genset Controller 2020-02-20 Version 1.0 Page 14 of 69
5.3
LCD DISPLAY
5.3.1
MAIN DISPLAY
Main screen show pages; use
to scroll the pages and
to scroll the screens.
★
Main Screen
includes following contents:
1) Partial status display;
2) AC Gens: voltage, frequency,
3) AC Load: current, active power, reactive power, power factor;
4) DC Gens: voltage, current, power;
5) Engine: speed, temperature, oil pressure;
NOTE:
It will screen scroll display circularly if screen scroll operation is not done after entering the main screen.
★
Status
includes,
Status of genset and ATS;
★
Engine
includes,
Speed, temperature of engine, engine oil pressure, fuel level, Configurable Sensor 1, Configurable Sensor 2,
battery voltage, charger voltage, accumulated run time, accumulated start times, user A and user B
accumulated start times.
NOTE:
If engine information are read by J1939 via CAN BUS port, then Engine page also includes: coolant pressure,
coolant level, fuel temperature, fuel pressure, inlet temperature, outlet temperature, turbo pressure, fuel consumption,
total fuel consumption etc. (Different engines include different data.)
★
AC
Gens
includes,
Phase voltage, Line voltage, frequency, phase sequence.
★
AC
Load
includes below,
Current of each phase, each phase and total active power (positive and negative), each phase and total
reactive power (positive and negative), each phase and total apparent power, each phase and average
power factor (positive and negative), accumulated energy, earth current and user A and user B accumulated
energy. .
NOTE:
Power factor shows as following,
Remark:
P stands for active power
Q stands for inactive power