Smartgen HAT600P Series, User Manual

Page: 49 / 58

HAT600P Series ATS Controller User Manual Page 49 of 58
Pin Items Description Notes
13 C1
14 N1
15 A2
S2 AC 3-phase 4 wire voltage input
For single phase, only connect
A2, N2 16 B2
17 C2
18 N2
19 B-
Connects genset start battery
negative;
Module GND connected terminal
20 B+
Connects genset start battery
positive when genset is started; DC positive input (8-35)V,
controller power
21 S1 close input
Detection of S1 switch closing
state, voltage free contact input
GND connected is active;
22 S2 close input
Detection of S2 switch closing
state, voltage free contact input
GND connected is active;
23 Aux. input 1
User defined
Default: Forced Open
GND connected is active;
24 Aux. input 2
Default: Breaker Trip Input
GND connected is active;
25 Aux. input 3
Default: Not Used
GND connected is active;
26 Aux. input 4
Default: Not Used
GND connected is active;
27
Aux. output 3 Voltage free relay N/O output
Default: S1 open control
Capacity 8A 250VAC
28
29
Aux. output 4 Voltage free relay N/O output
Default: S2 open control
Capacity 8A 250VAC
30
31
Aux. output 5 Voltage free relay N/O output
Default: self defined combination
output 1; Capacity 8A 250VAC
32
42
Aux. output 6 Voltage free relay N/C output
Default: genset start output
Capacity 8A 250VAC
43
36
IA Input Input of CT Secondary phase A
current
Rated current 5A
Only
suitable for
HAT600PI/HAT600PBI/HAT600P
S
37 IA Output
38 IB Input Input of CT Secondary phase B
current
39 IB Output
40 IC Input
Input of CT Secondary phase C
current
41 IC Output
44 120Ω Resistor
Match resistor for RS485
resistance
Users need to connect this
terminal with terminal 33 based
on the on-site situation to
connect this 120 Ω resistor into
the controller.
33
RS485 communication port
34 RS485 B-
35 PE
GND Connected terminal for
communication port
45 A3
Voltage input on load end
(50VAC-360VAC)
When load end wiring is being
done, parameter "Load Volt.
Monitor" is enabled; controller
default is disabled;
47 N3
USB USB D form USB communication port
Able to connect PC to configure
parameters
and software
upgrade;
ETHERNET Ethernet port Used for communication
Only suitable for
HAT600PBI/HAT600PS;