SMART Wallbox A0009069206, Instruction Manual, Page: 12 / 24

Please follow these steps to charge your smart vehicle using the wallbox:
1. Park your vehicle so that the vehicle charging socket can be easily reached with the charging con-
nector of the charging cable: The charging cable must not be stretched tight or placed under strain
during the charging procedure.
2. Open the vehicle charging socket as described in the vehicle's instruction manual.
3. Check the LED indicators at the front of the wallbox: When the wallbox is ready for operation, the
blue LED indicator will flash every 5 seconds, while the two other LEDs will be OFF.
4. Remove the charging connector from the charging connector compartment (model variant
A0009069206) or connect the separately available Mode 3 charging cable to the charging socket on
the right side of the wallbox (model variant A0009069306).
5. Insert the charging connector of the charging cable all the way into the vehicle’s charging socket.
6. If necessary, unblock the charging procedure using the key switch on the right side of the housing.
> Key switch in horizontal position: The next charging procedure is blocked.
> Key switch in vertical position: Charging procedure unblocked.
PLEASE NOTE!
Unblocking is only required to start the charging procedure: The key switch may be re-
turned to the horizontal position immediately afterwards and this will not interrupt the
charging procedure. However, after separating the connection with the vehicle, the next
charging procedure is again blocked by the wallbox.
Operating status is shown by the LED indicators on the front of the wallbox as follows:
LED display Description
The blue LED flashes every 5 seconds, the green LED and the red
LED are not illuminated. The vehicle may now be connected.
The blue LED is illuminated permanently when the vehicle has been
connected and detected but the charging procedure has not yet been
unblocked using the key switch.
The blue LED goes out and the green LED is illuminated perma-
nently when the vehicle is connected and the charging procedure has
been unblocked using the key switch: In this state, the wallbox is wait-
ing for the vehicle to initiate the charging procedure.
The green LED
flashes during the actual charging procedure. The
charging procedure can be manually interrupted at the vehicle and is
automatically terminated by the vehicle when charging is complete.
When the charging procedure is paused or completed, the green LED
is again continuously ON.