SMART SmartBoard 600 Series, User Manual

Page: 43 / 56

99-00850-21 A0 Remote Management of Your 600i2 Interactive Whiteboard System 35
The embedded firmware program coordinates command sequencing and is capable of buffering up to 127
commands. In each power state, the buffer accepts valid commands until the program can process them.
NOTES
• In the ON state, a five second delay occurs after every input source change. The program doesn’t process
commands during this delay.
• In the ON state, if the current input source doesn’t have a signal sent—that is, a black screen with the
SMART Technologies logo appears—a "Command Failed" message appears when you type contrast and
brightness commands.
Command Inventory
The Unifi 45 projector responds to the commands in the tables on the following pages. Commands are not case
sensitive. Type commands exactly as they appear in the left column of the tables, except for number variables,
represented by
xx , and positive/negative variables, represented by ± . Press ENTER after typing each command.
CAUTION
• Cycling power to the interactive whiteboard system repeatedly can lock or damage the
system or its components. Allow at least 15 minutes after turning off the system for cooling
before sending the ON command.
• Check your entries carefully before entering your commands.
IMPORTANT
After the projector executes a command, the projector generates a response. There are two ways to program the
command sequence to turn on the system, wait for the powering cycle to finish and select an input source:
• allow the ECP to sequence the commands
• control the sequence programmatically
Power state Commands Accepted
Idle The buffer accepts all valid commands.
The system processes the get fwver , get bootver , get input ,
get powerstate and on commands.
Powering The buffer accepts all valid commands.
The program doesn’t process commands.
On The buffer accepts all valid commands.
The program processes all valid commands.
Cooling The buffer accepts all valid commands.
The program doesn’t process commands.
The system buffer can delay response times. Response times vary.