SMART SmartBoard 600 Series, User Manual

Page: 4 / 56

ii Important Information 99-00850-21 A0
Safety Warnings
WARNING
• Do not stare into the beam of light created by the projector. Instruct children not to look in the
direction of, or stare at, this beam of light.
• Failure to follow the installation instructions included in this manual and other guides
packaged with the SMART Board 600i2 interactive whiteboard system could result in
personal injury or damage to the product.
• To reduce the risk of fire or electric shock, do not expose any component of the SMART
Board 600i2 interactive whiteboard system to rain or moisture.
• Two people are required to mount the projector and the interactive whiteboard on a wall
because they may be too heavy for one person to maneuver onto their wall-mounting
brackets.
• Do not climb (or allow children to climb) on any part of
the wall-mounted SMART Board 600i2 interactive
whiteboard system.
• Do not climb on, hang from or suspend objects from the
Unifi 45 projector’s arm.
• Climbing on the interactive whiteboard or projector arm
could result in personal injury or product damage.
• Do not attempt to service the projector other than
performing routine lamp replacement and cleaning the
mirror. Service should only be performed by an
authorized service provider. Aside from the lamp module,
there are no user serviceable parts inside the unit.
• Do not remove any screws other than those specified in
the lamp replacement instructions.
Other Precautions
To ensure operating safety and to avoid product damage, observe the following precautions.
• Do not set up or use the interactive whiteboard in an area with excessive levels of dust, humidity and
smoke.
• Do not add extra weight or apply pressure to the Unifi 45 projector arm, the wall-mounted interactive
whiteboard or its pen tray. SMART Technologies designed the brackets to support only the weight of the
components during normal use.
• To reduce the risk associated with leaking batteries:
– use only AA type batteries
– do not mix used and new batteries
– orient the battery’s plus (+) and minus (-) terminals according to the markings found on the remote
control
– do not leave the batteries in the remote control for an extended period
– do not heat, disassemble, short or recharge the batteries, or expose them to fire or high temperature
– avoid eye and skin contact if batteries have leaked