SMART SmartBoard 600 Series, User Manual

Page: 18 / 56

10 Before Installing Your 600i2 Interactive Whiteboard System 99-00850-21 A0
The image appears taller on the left side when the distance from the projector mirror to the left of the screen
is shorter than the distance to the right of the screen. The image appears taller at the right side of the image
when the distance from the projector mirror to the right of the screen is shorter than the distance to the left of
the screen.
Position the centre of the interactive whiteboard so that it aligns with the centre of the projector, as illustrated in
the installation document. This eliminates many keystone errors. If your installation environment prevents you
from moving the interactive whiteboard, you may be able to adjust the Unifi 45 mirror to correct image distortion.
NOTES
• If you move the interactive whiteboard system to a new location, you must re-align it.
• If your projector requires service, you must adjust the replacement projector.
To align the Unifi 45 projector mirror image
NOTE:
Do not attempt the following procedures unless you
are familiar with the procedures in the installation
document. Do not use the Unifi 45 projector digital image
adjustment options, because the interactive whiteboard
system does not support them.
1. Turn on the interactive whiteboard system.
2. Turn the thumb-screw (attaching the projector plate to
the boom) to adjust the image’s parallel alignment.
Turn the screw clockwise to tilt the projected image
higher on the left and counter-clockwise to tilt the
projected image higher on the right.
3. Turn the height adjustment screw (centre of three
screws) under the boom (resting on the pivot bolt) to align
the projector image’s top edge with the top of the interactive
whiteboard’s screen. Turn the screw clockwise to move the
image upwards and counter-clockwise to move the image
downwards.
WARNING
It takes two people to safely lift the interactive whiteboard on or off its wall mount bracket.
Thumbscrew
Height adjustment screw