SMART SmartBoard 600 Series, User Manual

Page: 41 / 56

99-00850-21 A0 Remote Management of Your 600i2 Interactive Whiteboard System 33
Remote Management of Your 600i2 Interactive
Whiteboard System
In This Chapter
This chapter has detailed instructions on how to set up your computer or your room control system to manage
your SMART Board 600i2 interactive whiteboard system settings.
• Programming Commands for Managing Your 600i2 Interactive Whiteboard System Settings
– Pin Configuration on the Extended Control Panel (ECP) RS-232 Connector
– Serial Interface Settings
– Timing and Command Processing
• Command Inventory
– To allow the ECP to sequence the commands
– To control the sequence programmatically
– Query Commands
– Projector Power Control Commands
– Set Commands
Programming Commands for Managing Your 600i2 Interactive Whiteboard
System Settings
You can connect a computer or room control system to the Unifi 45 projector’s serial interface (RS-232) to
externally manage projector settings. Using a computer connection or room control system, you can select video
inputs, start up or shut down the interactive whiteboard system and request information, such as projector lamp
usage and current settings.
Pin Configuration on the Extended Control Panel (ECP) RS-232 Connector
Pin configuration follows a three-wire connection, so that a straight through male to female RS-232 serial cable
connects to the serial device in the following arrangement.
Room Control System ECP RS-232 Connector
ECP RS-232 Connector
Pin Number
Receive Transmit 2
Transmit Receive 3
Signal Ground Signal Ground 5
NOTE: Depending on the manufacturer of your room control system, the pin arrangement might vary. Refer to
your room control system’s instruction manual for proper pin arrangement.