Note:
To remove the table from the printer, please, undo 4 knurled bolts from the bottom of the printing plate and
pull.
4. Connect the power cable and USB cable
5. Attach the holder and put on it the spool with plastic.
6. Filament loading
Feed the end of the plastic filament through the feeder tube holder
and the guide tube so that it appears about 10cm out the other
side.
Note:
To extend the extruder and nozzle lifetime it is recommended to
run the plastic filament through a piece of polyurethane foam
soaked in paraffinic or silicon oil.
