SMART Board SmartBoard 600i2, Configuration And User'S Manual

Page: 60 / 74

50 Remote Management of Your 600i2 Interactive Whiteboard System 99-00850-21 B0
• Press ENTER after typing each command.
After the projector executes a command, it generates a response. There are two ways to program the command
sequence to turn on the system, wait for the powering cycle to finish and select an input source:
• Allow the ECP to sequence the commands
• Control the sequence programmatically
CAUTION
• Cycling power to the projector repeatedly can lock or damage the interactive whiteboard
system. Allow at least 15 minutes for cooling before sending the ON command after turning
off the system.
• Check your entries carefully before entering your commands.
IMPORTANT
The system buffer can delay response times. Response times vary.