SMART Board M600ix3, Configuration And User'S Manual

Page: 43 / 114

CHAPTER 4
MAINTAINING THE INTERACTIVE WHITEBOARD SYSTEM
35 smarttech.com/kb/170910
3. Use the Phillips screwdriver to secure the captive screws.
IMPORTANT
Do not over-tighten the screws.
4. Close the lamp cover.
5. Connect the power cable to the wall outlet.
6. Press the Power
button once on the remote control to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp module in a secure container, and handle it gently until you recycle it.
To finish the projector lamp module installation
1. Turn on the projector.
2. Adjust the projector image if necessary (see Adjusting the image on page 23).
3. Access the service menu to reset the lamp hours (see Resetting the lamp hours on the next
page).
4. Activate the projector’s alert emails and lamp warnings if they’ve been deactivated (see Email
alerts on page 57 and Control panel on page 52).