SMART Board M600ix3, Configuration And User'S Manual

Page: 27 / 114

CHAPTER 3
USING THE INTERACTIVE WHITEBOARD SYSTEM
19 smarttech.com/kb/170910
Setting Use Notes
Default Opens the Reset to Default
screen, in which the user can
resets the projector settings to
their default values. If you select Yes, all projector settings reset
to their defaults, reversing any menu changes
you made. This action is irreversible.
Don’t adjust this setting unless you want to
reset all of the applied settings, or unless
you’re advised to by a SMART Support
specialist.
Network menu
Network and
VGA Out Activates the projector’s RJ45
(8P8C) connector and network
features.
Status Displays the current network
status (Connected, or
Disconnected). The default is Disconnected.
DHCP Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as On or Off. The default is off.
On enables a DHCP server on the network to
assign an IP address to the projector
automatically.
Off enables an administrator to assign an IP
address manually.
Password
Reminder Emails the network password
to the email address selected
in advance. See Web page management on page 51 to
set up a destination email address.
IP Address Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255. To change the projector’s IP address, use the
RS-232 connector or use a DHCP server to
assign a dynamic IP address, and then set a
static IP address using the network remote
management feature (see
Remotely
managing the system through a network
interface
on page 51).
Subnet Mask Displays the projector’s subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s
network gateway in values
between 0.0.0.0 and
255.255.255.255.