6
RAVEN MTi
Safety Information
Important Note About DVI Cables & Display
As in many studios, your computer may be located in a room far away from
your console. For DVI cable lengths over 15ft, a DVI signal booster is required.
This will ensure the video signal reaches the display with no signal degradation.
Additionally, when switching sources between DVI and HDMI for the display,
you must press the center button of the remote, or the source button on the
OSD board behind the meter access panel.
You must wait a full 6 seconds before the source will change.
Also there is no RGB input for the MTi. Although it will show as a source, it
should be ignored. It will take around 14 seconds to switch to the RGB source,
just be patient and move on to DVI when the RGB source is selected.
