IDP 700 Terminal Series - Hardware Guide
© SkyWave Proprietary 51 T206, Version 01
3.
Push the cable through the hole (Figure 50).
Figure 50 Cable without Housing
4.
Slide the plastic housing back onto the ferrule as far as it will go (Figure 49).
Figure 51 Locking Clip (removed) and Plastic Housing
5.
Press the locking clip, until you hear a snap, back into the main body (Figure 51).
Assemble a FAKRA Cable (optional)
To assemble a FAKRA cable, follow the assembly steps below. The example uses a
FAKRA straight female (J) connector. The FAKRA comes with two versions of the
contact assembly, namely a solder and a crimp type. In the case of the solder version,
solder the contacts rather than crimp them.
Figure 52 Connector Parts
1.
Strip the Insulator’s cable inner conductor, dielectric, and braid and jacket
(Figure 53).
Figure 53 Strip the Cable
2.
Insert the inner conductor into the contact pin (Figure 54). Crimp (or solder) the
center contact with the crimping tool.
3.
Slide the ferrule onto the cable (Figure 54).
A - Cable Inner Conductor
B - Dielectric
C - Braid and Jacket
Hole
Plastic Housing
Main Body
Contact Pin
Ferrule
Locking Clip
Cable / Ferrule
Plastic
Housing
Locking clip (removed)
Summary of Contents for IDP 700 Series
Page 70: ...www SkyWave com ...
